Loaded Chamber

This Sten MKII was built from a parts kit. Semi auto parts from Indianapolis Ordnance were used. The...

Machined an RMR and new rear sight on this Smith and Wesson M&P. The slide and frame were coated in ...

Glock 43X with some mill work to the slide. Scalloped the front sides just slightly. Then cut some s...

This Galil Ace got a barrel cut, crown and re thread. Then the muzzle device pined and welded so ove...

These 2 Glocks got some mill work and Cerakote. Glock 45 and 43X. The slides have 3 cuts that go in...

This Killer Innovations P320 slide was Cerakoted at the same time as the Daniel Defense DDM4 I poste...

This Wolf T91 upper got cut to 11 inches and the crowned and rethreaded. A gas block from T91 tactic...

This Daniel Defense DDM4 came in with an approved form 1. The barrel was cut at 11.5, crowned and r...

This M92 kit was a virgin kit. It came in with the under folder hardware. The owner decided he wante...

This Yugo M72 parts kit was sent in with a ReCreater blanks receiver. Once the build was complete al...

Aug. 25, 2019 | by Loaded Chamber Team

Custom Full Service
GUNSMITHING

4555 S. Ft. Apache Rd., Suite 106, Las Vegas, NV 89147

702-586-3777

LoadedChamberLV@gmail.com